ODI Troy Lee Poignées design grip 130 mm

I ordered the black with pewter lock rings, very nice. These are not that difficult to install if you just take a step back and think about the concept of the split locks. Make sure to match the locks for each grip, hex head facing up. Before placing the screws in, take a large and thin flat tip screwdriver, place the lock on the grip, lining up the notches. Slightly twist the flat tip screwdriver in the opening of the lock while pushing down on the lock to the grip's notches. The locks will snap right on, repeat the process for each. Slide onto the handle bar one at a time, insert screw, insert end cap, tighten slowly, hand tight only, don't over tighten. That's it, not really difficult at all. The feel great, they hold great, and the really add a touch to my bike. Definitely recommend.

These are easy to install. The grips are tacky but not super tacky. The thickness of the grips gives you a good feel and you are in control of your bars

These grips don't only look good, but they "tac up" nice, after a few rides. The directional scale like blocks, offer a lot of grip as well. I have these installed on all bikes in my garage. I will continue to buy, as long as they keep making them.

Quizá un poco cortos para mi bici por el detalle que sobresale del exterior del puño. No molesta mucho pero de vez en cuando, si te apetece llevar las manos "tipo con los cuernos" es un poco difícil. Creo que los pondré mirando al suelo y lo solucionaré. Me hice 900 km. en 18 días y sin problema. Quizá en algún momento si noté cierta dureza, pero muy puntual.

Love these grips. Gloves are a must but even when my gloves get soaked with sweat these grips do not slip. Without gloves on the grip is very rough on your hands and any moisture on your hand will make it slip. The grip does not feel think like some grips and the ridge on each side keeps our hand where it belongs.